Issue with DIGSI 5 v9.7 installation

hy.yam

I have a problem with DIGSI 5 V8.40 installation. The story is I ran the setup.exe, follow the instructions, it was all fine, until at the end I decided to click Restart Later. After a machine restart some time later, it does not allow the installation to continue. When I ran the setup.exe again, it kept telling me that the machine has not restarted. Now I am stuck in this and there is no way to proceed further or rollback. I then installed V8.00 instead, hoping this can get resolved later.

Hi. I'm experiencing the same issue with DIGSI 5 v9.7. I can't locate the FAQ's designated entries. Can you help me?

------------------------------------------------------------------------------------------
Split from Issue with DIGSI 5 V8.40 installation.

Likely, you have problems with user administrator rights. I had to do this:

1. Open a cmd where the installation files are
2. Run a command that restore the setup, in my case Setup.exe /P /L 1033 /B "Siemens DIGSI 5 V9.80" /RESTORE

That should solve it