LED light of physical module is not green and the output is not active

Marcjan

Hello,Common mistake, so in future set/reset conditions with a Flag or DB-bit.Then in one place set the outputs with the Flag{s} That way you handle the outputs at 1 place and you can easy see what condition is or is not met.Regards,Marcjan

Hello  marcjan
Well in my case output is set from my program just from one place but even then LED light of physical module is not green and the output is not active.
Kindly help me !

------------------------------------------------------------------------------------------
Split from LED light of physical module is not green and the output is not active.

Hello,

can you post info if you connect power source wires L+ and M to Output module? Also check Voltage with Multimeter on your source, also check backside bus connector. Give info.