SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Measuring Cylces 840D

6/24/2009 4:35 PM	Rate (0)
DWoody Posts: 6 Rating: (0)	When using _TSA in measuring cycles on 840D, the system automatically inhibits cycle start and also displays an alarm when result is out of tolerance, but if I wanted to write a check prog depending on the results of the measuring cycle and inform the machine operator what the error is based on using IF OR logic etc can I override this automatic cycle start inhibit.
DWoody Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

6/25/2009 6:02 AM	Rate (0)
RAM81 Silver Member Joined: 3/3/2008 Last visit: 3/11/2025 Posts: 333 Rating: (52)	hi woody can you be specific which measuring cycle you are using? regards Ram

Suggestion To thank Quote Answer

6/25/2009 9:56 AM	Rate (0)
DWoody Posts: 6 Rating: (0)	I am using CYCLE978. Regards Woody
DWoody Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

6/25/2009 10:29 AM	Rate (0)
RAM81 Silver Member Joined: 3/3/2008 Last visit: 3/11/2025 Posts: 333 Rating: (52)	hi woody the cycle start inhibit can only be cancelled byNC reset only. the only thing as per my knowledgeis you have to increase the tolerance of the measuring parameters. regards Ram

Suggestion To thank Quote Answer

6/25/2009 10:35 AM	Rate (0)
DWoody Posts: 6 Rating: (0)	As I Thought, Thanks for that. I was just hoping there may have been a more useable way around this. Again Thanks Dwoody
DWoody Posts: 6 Rating: (0)
Suggestion To thank Quote Answer

9/1/2009 12:59 PM	Rate (0)
Jason. Experienced Member Joined: 7/13/2008 Last visit: 1/16/2025 Posts: 107 Rating: (9)	Is the cycle failing to let you past, simply because you choose too small of TSA? You can either write your own cycle that does exactly what you like, use an appropriate measure point and tolerances. How far off are your points from what you are expecting? If you use the standard cycles (andallow them to finish), you should be able to deal with any sort of logical operation afterwards from the probe results.

Suggestion To thank Quote Answer