Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Modifying "Line" object properties using scripts in WinCC Flexible 2008

Created by: mircoaie3 at: 9/14/2010 8:19 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

9/14/2010 8:19 AM	Rate (0)
mircoaie3 Bronze Member Joined: 10/26/2009 Last visit: 5/28/2024 Posts: 63 Rating: (11)	I need to modify dinamically the start-point and the end-point of a "Line" object, in a WinCC Flexible 2008 project. I know that the "width" and then "height" properties are read-only (I cannot change these properties): I can change only the "Left" and "Top" properties. The line is not horizzontal or vertical, then I cannot use "Rectangle" object instead "Line". Is there another way to modify the end-point of the line? Is there any optional external library to use for drawing run-time-modificable lines? Thank you very much!

Suggestion To thank Quote Answer

9/14/2010 11:23 AM	Rate (0)
Sandman Platinum Member Joined: 4/29/2010 Last visit: 8/12/2024 Posts: 1557 Rating: (161)	Hello, this isn`t possible. Please take a look at this FAQ, there you can find all objects and how they can be modify: http://support.automation.siemens.com/WW/view/en/24249449 best regards.
	Last edited by: Sandman at: 9/14/2010 11:31 AM
Suggestion To thank Quote Answer

9/14/2010 12:07 PM	Rate (0)
mircoaie3 Bronze Member Joined: 10/26/2009 Last visit: 5/28/2024 Posts: 63 Rating: (11)	Thank you Sandman, do you know any "alternative" way to draw an oblique line (like an external library, an ActiveX control, ...)? Thanks a lot!

Suggestion To thank Quote Answer

9/15/2010 3:00 PM	Rate (0)
Sandman Platinum Member Joined: 4/29/2010 Last visit: 8/12/2024 Posts: 1557 Rating: (161)	I am sorry but i don`t know alternative way.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on