Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Motor Tunning with Sinamic S 120

Created by: simaticmanager at: 5/26/2009 1:58 PM (14 Replies)

Rating (1)

Thanks 0

Result pages:: |; 1 | 2; |

15 Entries

Entries per page: 10 | all

7/31/2009 3:38 PM	Rate (0)
simaticmanager Posts: 150 Rating: (5)	dear dave, i checked thesteps(Automatic controller settings)as describedby u butthese are applicable ifservo mode is selected, Buti m working on vector mode. I need sugesstions with respect to vector mode. Pls help. regards simatic manager
simaticmanager Posts: 150 Rating: (5)	Last edited by: simaticmanager at: 7/31/2009 3:43 PM
Suggestion To thank Quote Answer

5/15/2013 10:41 AM	Rate (0)
mmtkaya Posts: 24 Rating: (0)	Hello Open starter , open your project , connect your CU (target system), open Drive Navigator open "Commissioning" , open "Motor Identification" there is 5 mode in this page.
mmtkaya Posts: 24 Rating: (0)
Suggestion To thank Quote Answer

6/25/2013 1:03 PM	Rate (0)
sushil dhariwal Posts: 3 Rating: (0)	if you have starter software then u can start a motor with the function "CONTROL PANEL".Make sure all drive parameters are proper.You can also make turing and stationaary mesurement via STARTER. Regards sushil
sushil dhariwal Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

2/12/2015 12:47 PM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by AutoGen_360480 is split to a separate thread with the subject how to do motor tuning for 3P induction motor for crane application. Best regards Min_Moderator

Suggestion To thank Quote Answer

8/7/2015 11:15 AM	Rate (0)
Min_Moderator Platinum Member Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4766 Rating: (122)	New question published by sedatcanar is split to a separate thread with the subject Automatic Controller Settings not appear on the Screen. Best regards Min_Moderator
	Last edited by: Min_Moderator at: 8/7/2015 11:16:18 AM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

SINAMICS_S

Follow us on