Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

NanoPC and NonSiemens Device

Created by: nano69 at: 11/14/2011 9:43 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

11/14/2011 9:43 AM	Rate (0)
nano69 Posts: 4 Rating: (0)	Dear Experts, I'm having problem with connexion between Industrial PC SIMATIC IPC 227D and NonSiemens Device (TouchScreen PRIMELCO Serie 8000 PRI-CHM.15CMR51025A with WinMate-Controller R5U-Prozessor). When starting the nanoPC (green led), the touchscreen doesn't light. Cable used: DVI (nanoPC) -- VGA (touchscreen) The touchscreen controller is loaded with the original MicroTouch firmware and configured for Standard parameters under Windows: Format: Tablet Mode: Stream Autobaud: OFF Speed: 9600 bauds Parameters: N81 (no parity, 8 data bit, 1 stop bit) Thanks.
nano69 Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

11/14/2011 10:58 AM	Rate (0)
grg Experienced Expert Joined: 3/2/2009 Last visit: 11/4/2024 Posts: 94 Rating: (8)	Hello nano69, you have to use dvi-d monitor - there is no signal for vga available on the Nanobox. Best regards, grg

Suggestion To thank Quote Answer

11/14/2011 11:24 AM	Rate (0)
nano69 Posts: 4 Rating: (0)	Thanks for your answer. Which Siemens touchscreen (15") do you recommended for nanoPC IPC227D ? Is there nanoPC that drives the VGA ?
nano69 Posts: 4 Rating: (0)	Last edited by: nano69 at: 11/14/2011 11:55 AM
Suggestion To thank Quote Answer

11/17/2011 9:13 AM	Rate (0)
grg Experienced Expert Joined: 3/2/2009 Last visit: 11/4/2024 Posts: 94 Rating: (8)	Hello Nano69, you can use SIMATIC FLAT PANEL 15 15 INCH TFT- DISPLAY WITH 1024X768 PIXEL RESOLUTION 24V DC AND 120/240V AC VGA, DVI-D INTERFACE There is no NanoBox with VGA available. Regs, grg

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on