Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Parameter of CP340 in Tia Portal V13

Created by: Smakl at: 10/27/2014 1:34 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

10/27/2014 1:34 PM	Rate (0)
Smakl Posts: 33 Rating: (0)	Hello!In Step 7 v.5.5 was button parameter to tune the module CP340. How to set the same parameters in Tia Portal V13?
Smakl Posts: 33 Rating: (0)
Suggestion To thank Quote Answer

10/27/2014 1:44 PM	Rate (0)
Kahl Platinum Member Joined: 12/16/2012 Last visit: 3/14/2023 Posts: 634 Rating: (123)	Hi! I think it is the same as with the other modules: right click on it and choose from the drop-down list "Properties" There you can choose which protocol, which character frame to use etc. (if that's what you'r asking)
	ALPHR Technology Europe
Suggestion To thank Quote Answer

10/27/2014 1:48 PM	Rate (0)
Smakl Posts: 33 Rating: (0)	In the case of Step 7 v.5.5 required additional installation package to activate the button "Parameter" In Tia Portal V13 in the properties is not possible to select the speed.
Smakl Posts: 33 Rating: (0)
Suggestion To thank Quote Answer

10/27/2014 2:22 PM	Rate (0)
Kahl Platinum Member Joined: 12/16/2012 Last visit: 3/14/2023 Posts: 634 Rating: (123)	Hi! I use V11, and I can set the transmission rate in the Properties window (if that is the speed you refer to). P.S. Yes, I know, I use an obsolete software. Attachment transm rate.JPG (85 Downloads)
	ALPHR Technology Europe
Suggestion To thank Quote Answer

10/27/2014 2:46 PM	Rate (0)
Smakl Posts: 33 Rating: (0)	Thanks, found all my carelessness
Smakl Posts: 33 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on