Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

PCS7 Multi Project, CPU going to STOP mode in simulator

Created by: tushu at: 3/17/2015 12:45 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

3/17/2015 12:45 PM	Rate (0)
tushu Posts: 16 Rating: (0)	hi i am working on PCS7 Multi Project. I am tying to run the project on simultaor but CPU is always going in stop mode . I am not getting what is the issue? ---------------------------------------------------------------------------------------------------- Split from PCS 7 Compendium (PCS 7 V8.1 / V8.0 / V7.1 / V7.0 / V6.1). Attachment Untitled.png (134 Downloads)
tushu Posts: 16 Rating: (0)	Last edited by: Min_Moderator at: 3/17/2015 2:16:49 PM New subject after splitting
Suggestion To thank Quote Answer

3/17/2015 1:15 PM	Rate (0)
Chandra Tiwari Posts: 247 Rating: (2)	Hi Tushu, Please check what is error in No. 2, some of the OBs might not downloaded, check what is that OB, i believe OB121/122 prog error OB, if some issue in your program which is causing your PLC in STOP mode. Just check all diagnostic buffers.
Chandra Tiwari Posts: 247 Rating: (2)
Suggestion To thank Quote Answer

3/17/2015 1:18 PM	Rate (0)
Chandra Tiwari Posts: 247 Rating: (2)	Dear Jspino, The link is showing like this : Unfortunately the page you requested is temporarily not available. You may find useful information on our homepage. Thank you very much for your understanding. Seems incorrect link?? Please share the other link.
Chandra Tiwari Posts: 247 Rating: (2)	Last edited by: RaviS at: 3/17/2015 1:19:25 PM edit
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on