PLCSIM coupling and SIMIT communication

Hello, 

I am new to SIMIT. But I have a problem with coupling. Description below.

I created my project in STEP 7 manager. then I exported symbol table from this project. I created PLCSIM coupling in SIMIT and imported symbol table from STEP 7 manager. 

When I want to test signal level simulation (PLCSIM running and started simulation in SIMIT), there is a problem that forced signals in SIMIT. When I force signal in SIMIT, nothing happens in PLCSIM on forced adress (no tick appears).

I will welcome all helpful advice.

Thank you

Hi,

what version of SIMIT are you using? And how your HwConfig is created? Do you use RIO modules?

Old versions of SIMIT are not supportiong profinet network and you have to use profibus setup.

New question published by mookie1983 is split to a separate thread with the subject SIMIT Issue.

Best regards
Jen_Moderator