Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Profibus communication with MAG 6000

Created by: Hajakz1 at: 2/10/2010 12:38 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

2/10/2010 12:38 PM	Rate (0)
Hajakz1 Posts: 4 Rating: (0)	Hello! I have installed a MAG 6000. It shall communicate over Profibus via a OLM fiberconverter to S7 400. I have added MAG in HW and the MAG says its in Dateaxchange mode. But i just gets 0 when o look at PID744 in VAT. I use SLxx8129.gsd file I have tried to talk to Siemens support but i dont get any advice. Could anyone help please!
Hajakz1 Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

2/24/2010 1:14 PM	Rate (0)
Bilao Posts: 378 Rating: (47)	Did you try with online support request? Maybe they can help you Best regards bilao
Bilao Posts: 378 Rating: (47)
Suggestion To thank Quote Answer

2/24/2010 5:27 PM	Rate (0)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 12/4/2023 Posts: 10222 Rating: (1178)	Hello, Look at Please refer to the following link for the manual for the Profibus modules for the MAG6000: http://support.automation.siemens.com/WW/view/en/22437482 On page 21, an example is displayed how to integrate it in a S7 system. Compare with your settings. Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on