Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Profibus Faults

Created by: zhenisbek at: 5/29/2019 5:56 AM (2 Replies)

Rating (0)

Thanks 3

3 Entries

5/29/2019 5:56 AM	Rate (0)
zhenisbek Member Joined: 6/15/2018 Last visit: 11/15/2021 Posts: 4 Rating: (0)	On the machine CPU 315F-2PN/DP is installed as Master and X20 CP 1484 as Slave. This slave X20 CP 1484 with IF 1063 was burnt and I replaced it with CP1483. After installation of the new CP 1483 there was a fault on Profibus network and these warnings appeared: 'DP slave not ready yet for data exchange', 'Different configuratin data', 'Parameters must be assigned to DP slave again', 'Watchdog activated'. Profibus cable is healthy and terminatig resistor is in correct position. What might be wrong? Are these two CPs 1484 and 1483 compatible?

Suggestion To thank

5/29/2019 6:01 AM	Rate (0)
ixo65 Grandmaster Joined: 12/18/2014 Last visit: 9/29/2023 Posts: 30898 Rating: (3838)	Hello zhenisbek, please be so kind and don't post twice or more for the same problem. Thanks.

Suggestion To thank
This contribution was helpful to 2 thankful Users Jen_Moderator zhenisbek

5/29/2019 7:41 AM	Rate (0)
Jen_Moderator Moderator Joined: 6/19/2017 Last visit: 9/29/2023 Posts: 7351 Rating: (145)	Closed cause question posted twice. The second thread with the subject Profibus Faults is published within the conference Decentral Peripherie. Best regards Jen_Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards Jen_Moderator
Suggestion To thank
This contribution was helpful to 1 thankful Users zhenisbek

|

Share this page:

Share this page on...

Follow us on