Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

RGBS Connector on CP526

Created by: rusli_rusli at: 6/11/2009 10:51 AM (2 Replies)

Rating (0)

Thanks 0

3 Entries

6/11/2009 10:51 AM	Rate (0)
rusli_rusli Bronze Member Joined: 3/31/2009 Last visit: 4/18/2023 Posts: 191 Rating: (3)	Hii, On CP526 there's 4 connector for video output which is R,G,B,S.. on my current installation only used 3 connector (R,G,B) which is i assume the sync signal must be combine into G channel.. if i want to used all the connector (R,G,B,S) instead of RGB+Syn on Green, is there any configuration that i need to adjust or i just plug the connector ? BR Rusli

Suggestion To thank Quote Answer

6/11/2009 8:44 PM	Rate (0)
jklm Platinum Member Joined: 12/22/2006 Last visit: 1/25/2022 Posts: 1742 Rating: (305)	Hello, In this manual http://support.automation.siemens.com/WW/view/en/23772243 on page 3-77 you will find the jumper settings for the SYNC signal (separated or on Green)
	Best regards jklm Suggestion was helpful? Feel free to rate it.
Suggestion To thank Quote Answer

6/12/2009 5:10 AM	Rate (0)
rusli_rusli Bronze Member Joined: 3/31/2009 Last visit: 4/18/2023 Posts: 191 Rating: (3)	Dear EDR thx for your information br rusli

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on