Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

RS485+ USS with G110

Created by: Venture at: 3/13/2006 7:33 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

3/13/2006 7:33 PM	Rate (0)
Venture Posts: 2 Rating: (0)	I postedthis question in the communication but someone said that it's better to post here Iwant to communicate with G110 symatic drive to change value on frequence of G110 using a Visual basic 6 program and RS485. l'll use the USS protocol I dont know exactly what to putinto thetrame to communicate with the G110 drive I would like a example of trame. I only need to change the parameter p2000 (freq value) in the drive does somebody know the right trame to change the parameter p2000 in the drive G110 with the USS protocol ? TRAME >> STX LGE ADR PKW PZD BCC stx seems to be always (02H) lge is the length ofthe trame after the LGE ADR is the adress of the drive
Venture Posts: 2 Rating: (0)	Last edited by: Venture at: 3/13/2006 7:56 PM
Suggestion To thank Quote Answer

2/15/2007 10:26 AM	Rate (0)
miami Platinum Member Joined: 8/31/2005 Last visit: 11/13/2024 Posts: 2198 Rating: (328)	Hello, look at section 4 in this document: http://support.automation.siemens.com/WW/view/en/24178253
	Last edited by: miami at: 2/15/2007 10:26 AM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on