Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S7-300 Software Redundancy and Y-link

Created by: medaadi at: 3/27/2013 1:23 AM (2 Replies)

Rating (0)

Thanks 3

3 Entries

3/27/2013 1:23 AM	Rate (0)
medaadi Posts: 27 Rating: (0)	Hi, I want to communicate some Siemens componements (Simocode) with a S7-300 Redundant System. Can i use y-link (2 x 153-2BA02 and 1 x 197-1LB00) for this need? If not can you propose other solutions? Thanks, Med AADI
medaadi Posts: 27 Rating: (0)
Suggestion To thank Quote Answer

3/27/2013 2:53 AM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 10/3/2024 Posts: 12283 Rating: (2685)	Hello Med ADDI; I think you should look up the following discussion from last year, it might give you some hints, from some of the best participants on the forum: SIPROTEC Relays on Profibus with S7-300 SWR Hope this helps, Daniel Chartier
	Last edited by: dchartier at: 3/27/2013 3:01 AM
Suggestion To thank Quote Answer
This contribution was helpful to 3 thankful Users fritz medaadi iNano

3/30/2013 7:41 PM	Rate (0)
medaadi Posts: 27 Rating: (0)	Hi Dchartier, Thank you first for your reply. I add a CP345 in each S7-300 in my SWR system, i want to use it to get data from different slaves (i have some Simocode). Now in Step 7 i can't put both of CP345 in the same Profibus network with different adresses, but when i try to add Simocode, Step 7 tell that i have to link it with one Master. Seems legit :) I don't know if i have to put each CP345 in a network and give them the same adress and add to each of these networks all Simocodes or there is another way to release communication with other slaves in SWR systems? Thanks,
medaadi Posts: 27 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on