Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

SIWAREX U MODULE DOES NOT ALLOW ME TO ZERO CALIBRATE

Created by: Ruddy Romay at: 2/11/2021 2:08 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

2/11/2021 2:08 AM	Rate (0)
Ruddy Romay Member Joined: 8/29/2020 Last visit: 2/11/2022 Posts: 4 Rating: (0)	HI, EXPERTS WHAT CAN I DO IF A SIWAREX U MODULE DOES NOT ALLOW ME TO ZERO CALIBRATE FROM PCS7 AND THE COMMANDS ON THE FACEPLATE ARE LOCKED? THERE ARE FOUR SIWAREXU MODULES, TWO OF THEM ARE OUT OF CALIBRATED. WHEN I TRY TO MODIFY THE COMMANDS IN THE FACEPLATE, IT IS NOT POSSIBLE, IT DOES NOT ALLOW ME TO DISPLAY THE COMMANDS, IT DOES NOT ALLOW ME TO SEND THE SIWAREXU MODULES TO ZERO. THERE ARE 2 MODULES THAT DO ALLOW ME TO CALIBRATE THEM TO ZERO. WHAT CAN I DO TO SOLVE THIS PROBLEM Attachment WhatsApp Image 2021-02-10 at 18.13.03.jpeg (256 Downloads)

Suggestion To thank Quote Answer

2/11/2021 5:03 PM	Rate (0)
Siwarexi Gold Expert Joined: 1/4/2007 Last visit: 12/8/2023 Posts: 1071 Rating: (165)	Hello AutoGen, Did you switch in the faceplate from Auto-mode to Manual-mode? Best regards Siwarexi

Suggestion To thank Quote Answer

2/11/2021 5:57 PM	Rate (0)
Ruddy Romay Member Joined: 8/29/2020 Last visit: 2/11/2022 Posts: 4 Rating: (0)	HELLO SIWAREXI. THANKS FOR ANSWERING. THE FACEPLATE IS IN MANUAL MODE. BUT IT DOES NOT ALLOW ME TO MODIFY THE COMMANDS. Attachment WhatsApp Image 2021-02-10 at 12.28.22.jpeg (240 Downloads)
	Last edited by: Jen_Moderator at: 02/12/2021 06:30:05 Edited text for better reading.
Suggestion To thank Quote Answer

2/12/2021 1:13 PM	Rate (0)
Siwarexi Gold Expert Joined: 1/4/2007 Last visit: 12/8/2023 Posts: 1071 Rating: (165)	Hello AutoGen, 1. Did you install the Siwarex U OS-software exactly on that computer, where you would like to work with the faceplates? 2. Open WinCC and start once the OS-projecteditor. Best regards Siwarexi

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on