Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Source/sink, active/passive analog input

Created by: ZigaK at: 4/14/2014 2:33 PM (3 Replies)

Rating (2)

Thanks 0

4 Entries

4/14/2014 2:33 PM	Rate (1)
ZigaK Posts: 5 Rating: (1)	Hi everyone, I have a question about the analogue input card6ES7331-7KF02-0AB0. Is it possible to connect/configure both active and passive 2-wire instruments? In one case, the Siemens card would act as a source, and in the other, as a sink. Thank you! Žiga
ZigaK Posts: 5 Rating: (1)
Suggestion To thank Quote Answer

4/14/2014 2:47 PM	Rate (0)
Aret Posts: 2348 Rating: (263)	Yes, for different groups (2 channels in group) you can configure different schemes.
Aret Posts: 2348 Rating: (263)
Suggestion To thank Quote Answer

4/14/2014 2:56 PM	Rate (0)
ZigaK Posts: 5 Rating: (1)	Thank you for your quick reply! How exactly do I configure this? Is the configuration only done in software, or does the wiring need to be different? Can you refer to a specific page in the manual, where this is described? Thank you, Žiga
ZigaK Posts: 5 Rating: (1)
Suggestion To thank Quote Answer

4/14/2014 3:36 PM	Rate (1)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 11/27/2023 Posts: 8596 Rating: (1139)	Hello, Here is a link to manual: SIMATIC S7-300 S7-300 Module data See chapter 6.7 Best regards, Wizard

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on