Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

The f module is not switching to the required operation

Created by: deco10 at: 9/8/2020 8:33 PM (3 Replies)

Rating (1)

Thanks 1

4 Entries

9/8/2020 8:33 PM	Rate (0)
deco10 Posts: 52 Rating: (1)	Hi :) Please if somebody can tell me what is the reason about this message? I think the configuration in Hardware config and wiring are good but i see this message when i go online. Please if somebody can help me with this problem. Best regards. Deco10 Attachment 119043900_612904572751319_9192817710403488783_n.jpg (431 Downloads)
deco10 Posts: 52 Rating: (1)
Suggestion To thank Quote Answer

9/8/2020 8:34 PM	Rate (0)
deco10 Posts: 52 Rating: (1)	Attachment 119001826_2706233506298125_3678672911773173472_n.jpg (420 Downloads)
deco10 Posts: 52 Rating: (1)
Suggestion To thank Quote Answer

9/8/2020 9:37 PM	Rate (1)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 11/18/2024 Posts: 12294 Rating: (2691)	Hello Deco10; Have a look at these suggestions for ET 200SP failsafe modules: What should you check when the F destination addresses cannot be assigned? https://support.industry.siemens.com/cs/ww/en/view/109743502 Hope this helps, Daniel Chartier

Suggestion To thank Quote Answer

9/17/2020 3:12 PM	Rate (0)
deco10 Posts: 52 Rating: (1)	Hi I made a mistake during doing this. I always went on RIO and try to addressing but I should press on the safety card and then it's possible. Just if somebody makes this mistake. Best regards.
deco10 Posts: 52 Rating: (1)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users dchartier

|

Share this page:

Share this page on...

Follow us on