Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TIA portal V11 remote programming

Created by: MarjanMM at: 1/30/2014 3:34 PM (2 Replies)

Rating (0)

Thanks 1

3 Entries

1/30/2014 3:34 PM	Rate (0)
MarjanMM Posts: 51 Rating: (1)	Hello everyone, I have a problem with remote programming of my S7-1200 PLC. My PLC is behind router. My local IP address is 192.168.1.5. On my router i have made port forwarding of port 102. If I download only changes of the program it is working OK. If I make a complete download of the program my local IP address changes to IP address of my router. How to download the complete program, so my local IP address doesn't change. I set the IP address to connect to plc in the Device configuration/Ethernet addresses/IP protocol/ Set IP address in the project Best regards
MarjanMM Posts: 51 Rating: (1)
Suggestion To thank Quote Answer

1/31/2014 10:14 AM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 2/12/2025 Posts: 4403 Rating: (1470)	Hi, Did you place the router intern address asS7-1200 router address? Did you place the router extern address as your PC ethernet card gateway addreess? IS your STEP 7 V11 SP 2 upd5?
	Last edited by: Pegaia at: 1/31/2014 10:15 AM Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Tomy Master

1/31/2014 7:54 PM	Rate (0)
MarjanMM Posts: 51 Rating: (1)	Hello! I know what I am doing wrong. I have to use the setting Set IP address using different method. Best regards
MarjanMM Posts: 51 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on