Navigation

TIA Portal v13 (Alarms)

Created by: luksob at: 12/30/2014 11:48 AM (1 Replies)

12/30/2014 11:48 AM	Rate (0)
luksob Posts: 3 Rating: (0)	Hi all, 1. I have a question regarding alarms in TIA Portal v13. Is it possible to change status (from logic 1 to logic 0) of bit which activate alarm - I want to activate alarm when trigger value is 0, not 1. For example: 1. I have circuit braker. When it is activated (logic 1) everything is ok and it shouldn't activate alarm. However when it will shut down (logic 0) alarm should be activated. I can't find any possibility to change it - it is only possible to activate alarm with logic 1. Or I have to create extra FB block in my programm which will reverse all alarm values, e.g.: --\|I0.0\|----\|NOT\|---\|DB0.DBX0.0\| However it is a lot of work - I have almost 200 alarms. 2. Second question: If there is alarm, I don't want to activate extra screen on HMI panel with alarms - I want to have screen with alarms, however operator has to activate this screen by button to see alarms. How to change it - now when there is alarm or warning extra screen appears on HMI panel - it can be annoying. Greetings, Lukasz
luksob Posts: 3 Rating: (0)	Last edited by: luksob at: 12/30/2014 11:55 AM Last edited by: luksob at: 12/30/2014 11:54 AM
Suggestion To thank Quote Answer

12/31/2014 8:10 AM	Rate (0)
Wizard Diamond Expert Joined: 4/24/2006 Last visit: 2/17/2025 Posts: 8850 Rating: (1181)	Hello, Are you using a Panel? Which one? Best regards, Wizard

Suggestion To thank Quote Answer