Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

To acquire Data of a Panel for a PC

Created by: Marques at: 6/6/2006 11:21 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

6/6/2006 11:21 AM	Rate (0)
Marques Posts: 126 Rating: (2)	I want to acquire data of a panel for a PC,to save the data in a Data Base and then makeanalyzes of that data. The Panel is in a connected to a PLC, and reads information from it. I want to have acess to that information. Can you tell what i need to do. -Do i need to acquire any tool from siemens (something like Prodave)? -Was this simpler, if the Panel was converted to WinCC Flexible? Regards, Marques
Marques Posts: 126 Rating: (2)
Suggestion To thank Quote Answer

6/6/2006 11:26 AM	Rate (0)
Nemo Posts: 3149 Rating: (171)	Hi, this issue has already been discussed for Wincc Flexible: /tf/WW/en/Posts/2211 /tf/WW/en/Posts/3295 nemo
Nemo Posts: 3149 Rating: (171)
Suggestion To thank Quote Answer

6/6/2006 11:50 AM	Rate (0)
Marques Posts: 126 Rating: (2)	Ok but what about in Protool is there any similar solution? Regards, Marques
Marques Posts: 126 Rating: (2)
Suggestion To thank Quote Answer

6/6/2006 12:56 PM	Rate (0)
Nemo Posts: 3149 Rating: (171)	Hi, I found this nice FAQs [:D] http://support.automation.siemens.com/WW/view/en/22601445 http://support.automation.siemens.com/WW/view/en/5155752 http://support.automation.siemens.com/WW/view/en/23235548 http://support.automation.siemens.com/WW/view/en/22582012 http://support.automation.siemens.com/WW/view/en/22700159 http://support.automation.siemens.com/WW/view/en/13356589 nemo
Nemo Posts: 3149 Rating: (171)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on