Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

updade firmware for MCC 100

Created by: HOSSINI ABDEL at: 3/13/2010 1:03 PM (14 Replies)

Rating (0)

Thanks 0

Result pages:: |; 1 | 2; |

15 Entries

Entries per page: 10 | all

3/18/2010 12:37 AM	Rate (0)
HOSSINI ABDEL Posts: 7 Rating: (0)	hello You find here an another image of the screen of the HMI. thank you Attachment picturehmi 2.JPG (154 Downloads)
HOSSINI ABDEL Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

3/18/2010 12:39 AM	Rate (0)
HOSSINI ABDEL Posts: 7 Rating: (0)	hello You find here a third image of the screen HMI. thank you Attachment picturehmi 3.JPG (128 Downloads)
HOSSINI ABDEL Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

3/19/2010 12:35 PM	Rate (0)
CNC Chennai Experienced Member Joined: 12/5/2006 Last visit: 5/26/2023 Posts: 177 Rating: (2)	Hello 1)Take some Photos of MMc HMI Back Side . so that we can confirm Hard Disk Avaiability. 2) Go to Services Menu . Data OUt. Take some Photos . We can see Backup Avaiable on HMI or Not. Regards S.Dharmalingam

Suggestion To thank Quote Answer

3/19/2010 12:41 PM	Rate (0)
CNC Chennai Experienced Member Joined: 12/5/2006 Last visit: 5/26/2023 Posts: 177 Rating: (2)	Hello Take some Photos of HMI Back side - to Confirm Hard Disk avaibility Press SERVICES menu take some Pictures to find Back up Hard disk. Attach these photos for problem solving Regards Dharmalingam

Suggestion To thank Quote Answer

3/19/2010 6:59 PM	Rate (0)
Jason. Experienced Member Joined: 7/13/2008 Last visit: 9/20/2024 Posts: 107 Rating: (9)	Shopmill first ran on the MMC100-100.2, but after V5 of the HMIsw, the MMC100 would no longer be ideal (I think it required 12mb internal flash). Shopmill V4.x should run okay on the MMC100 generation 1. Some builders ran Shopmill in parallel with MMC103 software. I think at that time.. Manualturn and Shopmill on the MMC100's, Autoturn (and Autoturn plus) for the mmc103. It is hard to believe that this era is more than ten years ago. Hussini, The reload is pretty straightforward of this system. It is likely that you are close to a Siemens service engineer that can make short work of this.
	Last edited by: jason.polensky at: 3/19/2010 7:26 PM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on