V90 & EPOS: Acceleration & Deceleration Ramps For Jog Movement

Hello!

It's possible to do the same thing with V90 PN and EPOS?

zako

The Troodon

Dear Team,

I have been using s110 for basic positioner application using standard telegram 111. As you know, there are p2585 EPOS jog1 setpoint velocity and p2586 EPOS jog2 setpoint velocity parameters. I defined those as 30000. Also there is p2646 EPOS velocity override parameter that can be defined as 50% - 100% etc.

I want to change acceleration and deceleration ramps of jog movements. I could not find any relevant parameter for this. My jog movement is not able to reach its max speed in a short time at the moment. Can you tell me what I can do about this?

Thanks for your attention.

 .. usé MDI and Setup- Mode. There you can use the acceleration and deceleration override.

------------------------------------------------------------------------------------------
Split from Acceleration & Deceleration Ramps For Jog Movement.

Closed cause question posted twice.

The second thread with the subject EPOS Tel111 - Stop axis with specific deceleration and jog parameters is published within the conference SINAMICS general.

Best regards,
Jen_Moderator