Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Without conneting the loadcell Siwarex U giving the SF whats reason..?

Created by: MS1981 at: 11/30/2013 11:13 AM (13 Replies)

Rating (0)

Thanks 0

Result pages:: |; 1 | 2; |

14 Entries

Entries per page: 10 | all

12/2/2013 11:48 PM	Rate (0)
Chook Experienced Member Joined: 6/13/2006 Last visit: 9/21/2023 Posts: 201 Rating: (8)	Dear Sarfraz, LED SF ( systems fault ) Sorry for the delay in reply, however another people had asisst you a very good point that the connection was not correctly. The “Zero offset in uV/V” (unit =μV/V), and the “Characteristic value” (unit = mV/V) These values are taken from the respective load cell measuring log. If the measuring logs aren’t available, the default-values can be used, Try the address 256 , it should work Regards chook
	[IMG]http://i17.tinypic.com/66b7jas.jpg[/IMG]
Suggestion To thank Quote Answer

12/17/2013 2:18 PM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 12/19/2024 Posts: 4114 Rating: (195)	follow up question published by Sarfraz Bhattiis split to a seperate thread with the subject Configure the SIWAREX-U load cell Wire Break alarm message in Hmi Best regards CS Moderator
	My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank Quote Answer

12/18/2013 10:34 AM	Rate (0)
MS1981 Silver Member Joined: 4/14/2010 Last visit: 11/11/2024 Posts: 525 Rating: (11)	Dear Chook, i am facing the problem with copy the block from program GS_U02_V12. after compile warning message appear, following are ambiguous address T %DB9.DBD30 T %DB9.DBD34 T %DB9.DBD38 Fc Execute command (FC30) Network 1,Avoid absolute access to the local data stack. Define a temporary variable in the block interface.,0,1,18:41:38 Network 9,Access to %LD4 with ambiguous address Network 9,Access to %LD8 with ambiguous address i wish to use only attached Scale View screen how can i merge this program in my project. we received this program with SIWATOOL Cd from Siemens that was creat with TIA PORTAL V12 But we Have TIA PORTAL V12 SP1 Update 3 and program working good. Is there any error occure after conversion...?? 2nd problem the following Error message not reset automatically after LC connecting no SF fault appear but message not rest in hmi. Can i reset this manualy..?? Siwarex u - ch1 ext power supply DB9.DBX106.0 Thanks Attachment Scale.jpg (312 Downloads)
	MS
Suggestion To thank Quote Answer

2/17/2014 1:09 PM	Rate (0)
Siwarexi Gold Expert Joined: 1/4/2007 Last visit: 12/17/2024 Posts: 1166 Rating: (175)	Hello Sarfraz Bhatti, Don’t worry about the warnings in TIA Portals. You can ignore these warnings. These messages are only warnings and no error messages. On the FB45 you can see at the parameters “GROSS1” and “GROSS2” the weight values. If you click the button “Delete”: Don't the error message “Siwarex u - ch1 ext power supply” disappears? Best regards Siwarexi

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on