Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

How to downgrade to v5.6?

Created by: Strini at: 9/28/2021 2:26 PM (2 Replies)

Rating (1)

Thanks 2

3 Entries

9/28/2021 2:26 PM	Rate (0)
Strini Experienced Member Joined: 9/10/2012 Last visit: 9/11/2024 Posts: 68 Rating: (5)	I have project with WinCC Flexible integrated... How am I supposed to open them if "SIMATIC WinCC Flexible is not compatible with STEP 7 V5.7." ? I found this sentence here: https://support.industry.siemens.com/cs/document/109798574/ What's the better way to downgrade to v5.6? ------------------------------------------------------------------------------------------ Split from Step 7 Professional 2021 / 5.7 tragedy.
	Last edited by: Jen_Moderator at: 09/29/2021 08:26:23 New subject after splitting
Suggestion To thank Quote Answer

9/29/2021 8:54 AM	Rate (1)
Towome Platinum Member Joined: 7/9/2015 Last visit: 11/14/2024 Posts: 4027 Rating: (603)	Hi, and what happends if you deacitvate "Monitor application integrity"? - it should work. Which Version of WinCC Flexible do you use? Use 2008 SP5 with newes Hotfix 5 Update (Hotfix) for WinCC flexible 2008 Service Pack 5 Regards, Towome
	If my post was useful, please rate me - if not, please tell me - thank you!
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Murof

10/25/2021 3:15 PM	Rate (0)
Murof Platinum Expert Joined: 8/3/2009 Last visit: 11/13/2024 Posts: 14165 Rating: (1774)	Hello Yes Towome is right. In the link above there is a special Patch for Integrity check using WinCC flexible 2008 SP5 Upd2 -> I Use ist and it works together with V5.7 Bye Murof
	If this Information really helps, you could use the Rate function
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Towome

|

Share this page:

Share this page on...

Follow us on