Hi,

I connect to BM (code 6ED1052-1CC08-0BA2) via LSC 8.4.1. I can upload the program and the program works.

I connect to the web server using a PC and Firefox . The login page comes out. What is the password? I tryed with LOGO, Logo and logo but no way, login fails code 0.

IF I try tu setup a password in LSC access control for LSC & LWE user, when I click on apply I am prompted for a password. Which password shoud I use? LOGO, Logo and logo fails, but even if it fails something is being written onto the BM, because from there on, when I try to connect to the BM, I am prompted for a password and all the passwords fails, even the one I tryed to setup in LSC acces control. Only way to be able to connect again to BM is to force the default settings on BM.

What is, or how should I setup, the password for login to web server?

What is, or how should I setup, the password for setting up a password for LSC & LWE user?

How do you enable and call the web server on LOGO! 8?

Hi,

I installed LOGO!SoftComfort in italian. Below I report the varios commands in english, translating from italian. Sorry if sometime the translation is not exactly the same as in an english installation.

I click on file, proprties, then I switch to the tab "online settings", then i connect. Once connected all the other commands become active and I click on "acces command settings".

I check "allow acces to web server" and chose only HTTPS.

I installed the certificate on the PC, open Firefox, input the IP address of the BM and the login page comes out.

What is the password for loggin in to web server?

Thank you.

In your second screenshot, I can see that you want to log in as a web guest and not as a web user.

If you want to log in as a guest, you can only observe the web server, but not perform any switching operations or change any values. You also have to activate the web guest separately.

I don't know of a default password for either the web user or the web guest.

However, I always assign a password for the web user in the access control settings.

Thank you.

Seing your post I realized that I did not scroll down and did not si the two boxes enable web user and web guest.

However I enabled web user and set a password.

I tryed more then once to be sure to imput the password correctly but still login fails see attachment.

Start a Support Request.

But describe your problem in detail.

Hi,

I eventually could login. I realized that the brawser showed the login page even when the BM was off. So I cancelled cronology on the browser, loads the login page and than could login.

Thank you.