Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

WinCC Flexible interface to a 3rd party contoller over modbus

Created by: david at: 11/16/2005 8:10 PM (1 Replies)

Rating (0)

Thanks 0

2 Entries

11/16/2005 8:10 PM	Rate (0)
david Posts: 1 Rating: (0)	I am investigating the connection of an MP270 panel (programmed with flexible) to a sixnet controller over Modbus 984. When I look at the addressing in Flexible it only allows me access to the 4XXXX parameters. Can I get access to parameters in the 37XXX range? Thanks! david
david Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

11/17/2005 9:10 AM	Rate (0)
Nemo Posts: 3149 Rating: (171)	Hi David, please check chapter6 in the manual, you may find some more informations for connecting via modbus http://support.automation.siemens.com/WW/view/en/18797249 If you need a special driver perhaps the following company could realize this for you: http://www.sympat.com/auftragsentwicklung/index.html Regards, Nemo
Nemo Posts: 3149 Rating: (171)	Last edited by: Nemo at: 11/17/2005 9:29 AM Last edited by: Nemo at: 11/17/2005 9:10 AM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on