Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Launch of sinumerik 840C

Created by: AutoGen_9835510 at: 12/16/2024 9:13 AM (15 Replies)

Rating (1)

Thanks 0

Result pages:: |; 1 | 2; |

16 Entries

Entries per page: 10 | all

12/21/2024 9:32 AM	Rate (0)
AutoGen_9835510 Joined: 12/16/2024 Last visit: 1/14/2025 Posts: 10 Rating: (0)	After I deactivated the Q axis and applied the configuration, these errors appeared. Attachment IMG-20241221-WA0000.jpg (13 Downloads)

Suggestion To thank Quote Answer

12/23/2024 11:23 AM	Rate (0)
AutoGen_9835510 Joined: 12/16/2024 Last visit: 1/14/2025 Posts: 10 Rating: (0)	I think these errors are due to incorrect configuration. Maybe there is a factory configuration for a specific machine or image? Attachment 20241222_141819.jpg (9 Downloads)

Suggestion To thank Quote Answer

12/23/2024 12:12 PM	Rate (0)
nulizhang Platinum Expert Joined: 10/17/2007 Last visit: 1/15/2025 Posts: 4143 Rating: (361)	You said you have good back up--I suggest you reload the backup from beginning. then any errors, picture them, do not change anything , Let me try to help you AutoGen_9835510 After I deactivated the Q axis and applied the configuration, these errors appeared.
	If you like my comments please use "Thank" bottom left or Rating Top right
Suggestion To thank Quote Answer

12/23/2024 9:14 PM	Rate (0)
AutoGen_9835510 Joined: 12/16/2024 Last visit: 1/14/2025 Posts: 10 Rating: (0)	I checked the control relays, some were problematic. After that I reloaded the configuration, disconnected the Q axis. It seems there are no more errors. There are only these messages. Attachment 20241223_231420.jpg (11 Downloads)

Suggestion To thank Quote Answer

12/24/2024 12:13 PM	Rate (1)
nulizhang Platinum Expert Joined: 10/17/2007 Last visit: 1/15/2025 Posts: 4143 Rating: (361)	Very good, the message numbers> 9000 all machine builder message. you can follow the message to fix the issue AutoGen_9835510 I checked the control relays, some were problematic. After that I reloaded the configuration, disconnected the Q axis. It seems there are no more errors. There are only these messages.
	If you like my comments please use "Thank" bottom left or Rating Top right
Suggestion To thank Quote Answer

1/13/2025 6:58 AM	Rate (0)
AutoGen_9835510 Joined: 12/16/2024 Last visit: 1/14/2025 Posts: 10 Rating: (0)	Thank you for your help. Everything worked!

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on