Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

AutoStart of WinLC v4.1 doesn't work after I checked

Created by: Torpedo1215a at: 4/21/2008 4:31 PM (5 Replies)

Rating (2)

Thanks 0

6 Entries

4/21/2008 4:31 PM	Rate (0)
Torpedo1215a Advanced Member Joined: 3/22/2008 Last visit: 2/25/2024 Posts: 63 Rating: (0)	Hi All, Does anyone know how to fix this problem? br, Torpedo

Suggestion To thank Quote Answer

4/22/2008 9:18 AM	Rate (1)
ST1985 Regular Member Joined: 5/23/2007 Last visit: 9/10/2008 Posts: 17 Rating: (3)	Have you registered your WinAC for the attempt? This only goes if into "current-free" is the WinAC. best regards ST1985

Suggestion To thank Quote Answer

4/22/2008 11:18 AM	Rate (0)
TomDeWou Platinum Expert Joined: 11/15/2006 Last visit: 5/7/2021 Posts: 1319 Rating: (174)	Did you set the autostart option and register the controller? Does the PLC doesn't change to RUN state or doesn'tthe controller start?
	Have Fun! TomDeWou
Suggestion To thank Quote Answer

4/26/2008 3:51 AM	Rate (0)
Torpedo1215a Advanced Member Joined: 3/22/2008 Last visit: 2/25/2024 Posts: 63 Rating: (0)	I didn't register it, I just set AutoStart option as checked, and then reboot. How could I register it?

Suggestion To thank Quote Answer

4/29/2008 4:42 PM	Rate (1)
TomDeWou Platinum Expert Joined: 11/15/2006 Last visit: 5/7/2021 Posts: 1319 Rating: (174)	shut down the controler (not the panel) by selecting CPU- Shutdown Controller. Then select CPU - Register Controller for start at PC boot. This one isactive if controller is stopped, only.
	Have Fun! TomDeWou
Suggestion To thank Quote Answer

5/1/2008 6:09 AM	Rate (0)
Torpedo1215a Advanced Member Joined: 3/22/2008 Last visit: 2/25/2024 Posts: 63 Rating: (0)	It's working well. Thanks.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on