Skip to Content

Register Login

工业业务领域支持中心

Technical Forum

Navigation

Diagnostic DO 6ES7 332-8BH01-0AB0 with 412-3H CPU

Created by: Deymus at: 5/26/2008 4:23 AM (3 Replies)

Rating (0)

Thanks 0

4 Entries

5/26/2008 4:23 AM	Rate (0)
Deymus Posts: 12 Rating: (0)	Hi Experts, Currently I am using Diagnostic DO 6ES7 332-8BH01-0AB0 with 412-3H CPU. I am not able to read the it diagnostic when there is a fault. I have used the same program for CPU 317 and it is working fine. Below is my program: CALL "DPNRM_DG" REQ :=M900.1 LADDR :=W#16#1FFB RET_VAL:=MW102 RECORD :=P#DB100.DBX0.0 BYTE 128 BUSY :=M901.0 Please help as i need this urgently... Thanks alot in advance.
Deymus Posts: 12 Rating: (0)
Suggestion To thank Quote Answer

5/26/2008 9:54 AM	Rate (0)
Aret Posts: 2348 Rating: (264)	1) SFC13 is for reading diagnostics from DP-Slaves. If you need DO in central rack, please use SFC51/59 2) Check "Diagnostic interrupt" checkbox (if there is any). 3) Check diagnostic address in HWKonfig PS) Please attach diagnostic buffer (if there are some errors) and HW configuration if you can.
Aret Posts: 2348 Rating: (264)
Suggestion To thank Quote Answer

5/26/2008 10:16 AM	Rate (0)
Deymus Posts: 12 Rating: (0)	Hi Experts, Attached is the printscreen for my hardware configuration. please help me see what is the SFC i should use. Attachment 2.JPG (392 Downloads)
Deymus Posts: 12 Rating: (0)
Suggestion To thank Quote Answer

5/26/2008 11:12 AM	Rate (0)
Aret Posts: 2348 Rating: (264)	Seems like SFC13 is what you need in such case. But your diagnostic address is 8186, and in CALL it's 8187. Do you use DPV1 or DPV0 in connecting ET200M and H-system? If DPV0 - did you choose ET200M from DPV0 Slaves folder?
Aret Posts: 2348 Rating: (264)	Last edited by: Aret at: 5/26/2008 11:14 AM
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on