Skip to Content

Register Login

工业业务领域支持中心

Technical Forum

Navigation

PG710 plus VGA output

Created by: aqualectra at: 8/18/2008 4:26 PM (4 Replies)

Rating (4)

Thanks 1

5 Entries

8/18/2008 4:26 PM	Rate (0)
aqualectra Regular Member Joined: 12/5/2007 Last visit: 8/21/2024 Posts: 4 Rating: (0)	I have a PG710 from a customer who dropped it and now the screen is broken. On the back is an VGA output, but if I connect a monitor it doesn't show anything. Is there some key sequence to put the PG710 in VGA mode or is this only possible by the BIOS? (If so I can't see that either ) Thanks in advance Roland

Suggestion To thank Quote Answer

9/2/2008 2:31 PM	Rate (4)
Kampf-Pasman Posts: 75 Rating: (13)	Press <CTRL><ALT> <s> during startup Wait 10 sec Page down Cursor right Plus from the numblock F10 F5 should work now.
Kampf-Pasman Posts: 75 Rating: (13)
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users melsec-

9/8/2008 3:44 PM	Rate (0)
aqualectra Regular Member Joined: 12/5/2007 Last visit: 8/21/2024 Posts: 4 Rating: (0)	Sorry for the late reply, I didn't have time to test it,until today. And it works!!!!! thanks a 1000000 Roland
	Last edited by: aqualectra at: 9/8/2008 3:44 PM
Suggestion To thank Quote Answer

9/8/2008 6:17 PM	Rate (0)
JMJ Posts: 487 Rating: (45)	Kampf-Pasman Press <CTRL><ALT> <s> during startup Wait 10 sec Page down Cursor right Plus from the numblock F10 F5 should work now. Good job there. Rated you for it.
JMJ Posts: 487 Rating: (45)
Suggestion To thank Quote Answer

9/9/2008 10:42 AM	Rate (0)
Kampf-Pasman Posts: 75 Rating: (13)	Thanks
Kampf-Pasman Posts: 75 Rating: (13)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on