7/12/2023 9:04 PM | |
Joined: 7/12/2023 Last visit: 7/12/2023 Posts: 1 Rating:
|
Hello, new to grp. I have a Simec MEC-200 cold saw with a S7-200 214-1AD21-OXBO PLC it apparently does not have the battery pack in it. It's controlled by a OP2 controller, I don't know what happened but the op2 is flashing through errors and restarts and will not run the program. I lost all my settings and parameters. I have reset all of them and still no auto it still will not run. thanks for reading have a good day. Michael ------------------------------------------------------------------------------------------ |
Last edited by: Jen_Moderator at: 07/13/2023 09:03:21New subject after splitting |
|
7/31/2023 11:27 AM | |
Joined: 10/16/2007 Last visit: 8/21/2024 Posts: 629 Rating:
|
Hello, I would suggest that the OP2 is broken. You could send it to Siemens to check and repais. Regards Scott |
Follow us on