Hi, Online Support,

TIA Portal V16 trial version with Wincc Unified was installed in VMware virtual machines (tried with both Win7 X64 and Win10 X64,), I can not run simulation for Unified Comfort Panel? but I can run simulation for Comport Panel in the same VM.

For this first trial project, I only put one empty main page in Unified Comfort. Nothing else and no HMI tag. 

See attached captured image of message feedback.

Bruce

------------------------------------------------------------------------------------------
Split from Basic Panels / WinCC Basic in WinCC Unified?.

cumulus

Hi MaxBruce,
I'm not sure, but try the following steps.

• Run the appication "WinCC Unified Configuration".
• Walk through until the step "Secure download".
• Disable "Activate secure download".
  (See picture attached.)
• Try your simulaiton again.

Hope this helps...

Best Regards,
cululus

Hi, cululus

It works. Thank you

MaxBruce