Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Logo extension card not getting detected in PLC.

Created by: 10Max01 at: 5/30/2024 3:29 AM (3 Replies)

Rating (1)

Thanks 2

4 Entries

5/30/2024 3:29 AM	Rate (0)
10Max01 Member Joined: 5/31/2022 Last visit: 8/22/2024 Posts: 18 Rating: (0)	Hi everyone, I am new to LOGO plc. just did few projected with basic module. I am trying to connect extension module with plc but its not getting detected. (No run /stop indication) after power on. Same 24v supply used for both module. Tried connecting PLC (6ED1052-IHB08-0BA1) with IO extension card (6ED1055-IMB00-0BA2) . same problem. Also tried PLC (6ED1052-IHB08-0BA1) + analog card (6ED1055-IMA00-0BA2). same problem. Replaced PLC and also extension cards one by one with new cards. Still facing same problem. All used plc and extension cards are brand new. just out of box so not possible that all are faulty. Am i missing something. DO i have to configure cards in software? (Cant find any configuration option for extension cards)
	Last edited by: 10Max01 at: 05/30/2024 03:42:25
Suggestion To thank Quote Answer

5/30/2024 4:19 AM	Rate (1)
ixo65 Grandmaster-Expert Joined: 12/18/2014 Last visit: 11/18/2024 Posts: 34239 Rating: (4263)	You can't configure anything, there is no menu for that in LOGO!Soft Comfort. The base module automatically detects an expansion module if the power supply for the expansion module is present and the contact slide of the expansion module is correctly engaged. Attachment LOGO! 8 manual 0BA8 2022_07 xxxx8-0BA1 pages 35-37.pdf (293 Downloads)

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users 10Max01

5/30/2024 6:08 AM	Rate (0)
10Max01 Member Joined: 5/31/2022 Last visit: 8/22/2024 Posts: 18 Rating: (0)	Thanks, I checked and found someone messed with my test bench and changed polarity of 24V supply. as extension card polarity sensitive its not getting on. after correcting polarity problem got solved.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users ixo65

5/30/2024 6:11 AM	Rate (0)
ixo65 Grandmaster-Expert Joined: 12/18/2014 Last visit: 11/18/2024 Posts: 34239 Rating: (4263)	10Max01 [snip] after correcting polarity problem got solved. That sounds good ...

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on