------------------------------------------------------------------------------------------
Split from PAC3200 PROFINET GSD.

I was hoping there would be an answer to this one. I am trying to communicate to our first PAC3220 using a typical Modbus TCP communication driver, KEPServer. Modbus TCP typically requires a node address in addition to the Ethernet IP address, I was unable to find this in the manual. If it is not operator adjustable often it could be 0 or 1, I have tried both. I also tried 126 because that would be the default for the PAC3120 with Modbus RS-485.

It fails when I try to read a float from 30001 or 40001. I haven't found anything that works yet.

Has anyone been successful at this? Should be common situation. Should be easy. I have done it with a lot of other devices.

Hello,

I have the same problem, maybe you found a solution ?