Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

FC106 (unscale) S7-300

Created by: Berg at: 4/8/2006 5:54 AM (1 Replies)

Rating (0)

Thanks 0

2 Entries

4/8/2006 5:54 AM	Rate (0)
Berg Silver Member Joined: 1/17/2006 Last visit: 10/14/2024 Posts: 553 Rating: (29)	Hi, Please, I have a question about S7-300. I have an application using a module with2 analog outputs (12 bits). Why when I insert a new object (FC106)it isinserted like a open block (not protected block) ?I can use this block like a normal block ...So, it is inserted like a normal FC andwhen I call this FC106 in a FB, it is called without the parametersshowed below: CALL"UNSCALE"FC106 IN := HI_LIM := LO_LIM := BIPOLAR:= RET_VAL:= OUT := It is called like this : CALLFC106 (without the parameters) Please, what is my mistake ??? Is there a library that must be installed to do this function (unscale) ??? See the picture attached. Thanks in advance, regards Berg Attachment fc106.JPG (885 Downloads)
	"Educate the children and it won't be necessary to punish the men." Pythagoras
Suggestion To thank

4/8/2006 1:48 PM	Rate (0)
CS Moderator Moderator Joined: 9/1/2005 Last visit: 10/25/2024 Posts: 4109 Rating: (195)	Closed: cause topic posted twice. Here you will find the second topic which is replied: FC106 (Unscale) S7-300in the conference STEP 7 / STEP 7 Lite
	Last edited by: O_Moderator at: 3/17/2010 11:38 AM conference-link edited My Forum is the place to personalize your profile, track your topics, and maintain content that interests you. Best regards CS Moderator
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on