Hello

I have a question.

Now I using Sinamic S7 (V5.4).

I am programming IEC Timer.

How IEC Timer total up time???

------------------------------------------------------------------------------------------
Split from IEC TIMER is not working.

You can find extra information In the Help section

TIME (IEC time)

The following table shows the properties of data type TIME:

It is not necessary to specify all time units. T#5h10s is a valid entry, for example. If only one unit is specified, the absolute value of days, hours, and minutes must not exceed the high or low limits. When more than one time unit is specified, the value must not exceed 24 days, 23 hours, 59 minutes, 59 seconds or 999 milliseconds.

If you need more time you can use

The following table shows the properties of data type LTIME:

It is not necessary to specify all time units. LT#5h10s is therefore a valid entry, for example. If only one unit is specified, the absolute value of days, hours, and minutes must not exceed the high or low limits. When more than one time unit is specified, the value must not exceed 106751 days, 23 hours, 59 minutes, 59 seconds, 999 milliseconds, 999 microseconds or 999 nanoseconds.