SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

sync time and date between a KTP Basic Panel and a LOGO! 0AB7

10/29/2014 3:16 PM	Rate (0)
Martin Brion Advanced Member Joined: 4/18/2013 Last visit: 7/12/2024 Posts: 17 Rating: (0)	I also need to sync time and date between a KTP Basic Panel and a LOGO! 0AB7... I was searching for a post about this but I cannot find anything. Is there some way to solve this issue? -------------------------- New subject after splitting from HOURS COUNTER ON LOGO 0BA7 AND HMI KTP400.
	Last edited by: Min_Moderator at: 10/29/2014 3:39 PM Splitted
Suggestion To thank Quote Answer

10/29/2014 3:53 PM	Rate (0)
Methos1111 Experienced Member Joined: 2/14/2014 Last visit: 5/27/2024 Posts: 115 Rating: (14)	Hey Martin, you can't sync the time between a KTP Basic an a Logo 0BA7. The 0BA7 don't makes available the time to read it with a KTP or something else. Sorry but so is the system of the Logo. Time sync is available with S7 1200 or higher. Best regards Methos

Suggestion To thank Quote Answer

10/29/2014 4:52 PM	Rate (0)
Martin Brion Advanced Member Joined: 4/18/2013 Last visit: 7/12/2024 Posts: 17 Rating: (0)	Thanks for your reply. If in the future the network conected to both panel and LOGO! is conected to a SCADA (winCC). Could sync time and date from there?

Suggestion To thank Quote Answer

10/30/2014 8:21 AM	Rate (0)
Methos1111 Experienced Member Joined: 2/14/2014 Last visit: 5/27/2024 Posts: 115 Rating: (14)	Hey Martin, first I have to say that Logo could only use 1 HMI-system in network. So you can communicate with the basic panel or the WinCC Scade but not both. The basic-panel gets the time an date with area pointer. Neither WinCC Scade nor Logo make date and time available on this way. So you can't sync the time in your network without a CPU which makes the date and time available for the HMI-system. Best regards

Suggestion To thank Quote Answer

Share this page:

Share this page on...