Hello everyone,

could someone point me out to a document describing LED status of IO-modules.

At the moment all IO-modules (upper LEds) of ET200SP are blinking green.

Thanks in advance!

Hi HBCM_,

you are talking about the DIAG-LED? A flashing DIAG LED means that the module parameters are not assigned. You will find further information at the corresponding equipment manual. E.g. for a SIMATIC ET 200SP digital input module DI 8x24VDC ST.

Kind regards
Stefan

Stefan Arcularius

Hi HBCM_,

you are talking about the DIAG-LED? A flashing DIAG LED means that the module parameters are not assigned. You will find further information at the corresponding equipment manual. E.g. for a SIMATIC ET 200SP digital input module DI 8x24VDC ST.

Kind regards
Stefan

 Have you meant this assignment (right mouse button click at DP network view)? Please take a look at the pic attached.

Hello HBCM_,

I guess it is not in the network view (your screenshot) but in the device view. When you select the IO module there and go to Properties > General you find "Module parameters". Maybe Channel is not acitvated.

Regards,

Frink

Hi,

What is meant by module parameters assignment please

ThanX

NIzGood

Hi,

What is meant by module parameters assignment please

ThanX

 Basically each IO module has a set of parameters. Device View - >Properties.

You can set needed parameters, then download HW changes.