Hi

I have a simotion D controller with a couple of drives connected to it. This is a working machine at one of the customers. I want to display the fault code number of each drive on the hmi. I managed to do it with one of the drives already, however for the second drive I noticed a issue.

Before picture summary:

In the before picture you will see for object one, that its Input and Output data starts at 400 and end at 403.

For the drive I want to extract the fault code from (object 3), the input data and output data starts at 380 and ends at 399.

After picture summary:

If I add the telegram extension on the drive I want to extract the data from and then use the set up addresses button from that window, it alerts me that there is not enough space for the input and output data (which make sense, since they are conflicting between the two), and that it will automatically shift the addresses. Once that is done, I noticed that it shifted the address locations of the object 3 (again, I understand and agree this needed to happen).

Now my question, is there a way to automatically update all symbol/tags (CPU and HMI) that was using the original data area of object 3 to the new data area of object 3 (This looks confusing, but I hope its readable and undestandable).

Regards