Dear Team,

I hope this message finds you well.

I have recently completed a project using WinCC Flexible SP3 software. However, I have discovered that the HMI components I require are not available in the library of WinCC Flexible but are instead found in the library of TIA Portal V14.

I am seeking guidance on whether there is a tool or method available that can assist in transferring my project to TIA Portal V14 without the need to recreate the entire program from scratch.

Any assistance or recommendations you could provide would be greatly appreciated.

Thank you for your support.

Best regards,

Hi,

Before the migration, you should check that the HMI operator panel used is supported by WinCC (TIA Portal) V15 or higher. If this is not the case, the HMI operator panel will be automatically replaced by the successor device during the migration. Please see the link below:

Migration of a WinCC flexible project integrated in STEP 7 V5.x to WinCC (TIA Portal) and upgrading of the operator panel version after a change of the WinCC (TIA Portal) version to a newer version.

You can also use the migration tool provided by Siemens:

Migration Tool TIA Portal