Hi there,

The problem I encountered is a little weird.

I got a new IOT2050 and tried to set it up, but I can not connect it via Putty ('Timed out'). Then I used IP Scanner to check the IP of IoT2050, and I found the IP was not the same as its default: 192.168.200.1. I got 192.168.10.111 instead. I also found the MAC address is not the same as the label on my IoT2050. (The last bit is different: Label: **-**-**-**-**-77, but the actual MAC is **-**-**-**-**-78).

The problem now is I am required a password when I first run the IOT2050. I connected this device via IP 192.168.10.111. I am not sure if it is because of the IP or something else?

If anyone has ideas, it would be very helpful. Thank you in advance :)

Hi,

Thank you for your response. I connect the X1P2 via a rooter now and I can found the IoT2050 at 192.168.200.1 via an IP scanner right now, but when I try to connect via Putty, a password is required. This is a new device, do you have any idea about this?

Hi,

I found the default password is root in the Forum. Thank you very much for your help! :)