Hi,

I'm still a student and new to Logo. I have tested my program and it works, but I would still like to make it better.

I have a motion sensor controlling the lighting in my project and push-buttons for turning them on/off. I also have a master switch that only turns off some of the lights. (It won't turn on anything.) There is also one power socket that turns on when the motions sensor is active.

My problem is, that when the motions sensor in the room goes off and all the lights go off too, as intended, I would like for the lighting scene to reset so to speak -> So that none of the lights are on when the motion sensor goes on again.

I used a latching relay for the push buttons and an off-delay for the motion sensor. AND- and NOT-gates are used for the function of the lights turning on when the motion sensor is active and a push button is used. (NOT-gate is for the master-switch)

Any tips or suggestions?