implement the Indirect tension control with Diameter computation.
Created by: SanjayaSrivastava1964 at: 8/17/2021 12:22 PM (2 Replies)
Rating 
Thanks 0
3 Entries
| 8/17/2021 12:22 PM | |
Joined: 8/2/2018 Last visit: 8/17/2025 Posts: 10 Rating:
|
Hi Hartik, Coould you implement the Indirect tension control with Diameter computation. I am looking for same solution for a project. Regards Sanjaya Srivastava ------------------------------------------------------------------------------------------ |
Last edited by: Jen_Moderator at: 08/17/2021 13:09:45New subject after splitting Regards |
|
| 8/17/2021 1:23 PM | |
Joined: 10/11/2006 Last visit: 1/8/2026 Posts: 6065 Rating:
|
Hello, please use the DCC winder application for SINAMICS DCM (6RA80). |
|
With best regards, |
|
| 8/18/2021 7:02 AM | |
|
Posts: 8171 Rating:
|
Closed cause question posted twice. The second thread with the subject Diameter Calculation in Winder application in 6RA80 is published within the conference SINAMICS general. Jen_Moderator |
Follow us on