Hi,

Does anyone know if it's possible to show the time stamp (Raise time) with milliseconds when using "Alarm control"? I've looked through all the variables in "Output format", but none of them displays milliseconds.

In the old "Alarm view" which I used for comfort displays, there was a checkbox for enabling milliseconds. I haven't managed to find this checkbox in "Alarm control"

I'm using TIA portal V17 with a MTP1900 Unified display

Best regards,

Sondre

Hi!

Try this Output Format under: Miscellaneous > Alarm Control > Columns > [22] Alarm Column (RaiseTime) > Output Format

{D,@yyyy.MM.dd HH:mm:ss.SSS}

Works for me in Runtime.

Hope it helps.

Thank you so much, that worked perfectly!

Do you know if this is documented somewhere? I tried to read through the documentation, but I didn't find anything

Unfortunately manual is too big so I can't attach it here, but I found it afterwards in the WinCC Engineering V17 - WinCC Unified manual on page 70.

I attach a screenshot from the page in the manual instead.