ixo65

 

Prxsh

I want to create a program where input 1 (momentary switch 1) will cycle the cylinder 20 times and input 2 (momentary switch 2) will cycle the cylinder 1000 times. 

 That's what you wrote.

 Yes my mistake. Do you think it is possible to do that on the program. So for example. When I press I1 the system will start to run 20 cycles and stop. Then when I press I2 the system will run and complete 1000 cycles. I am struggling to find a way to run the same program with the two different switches. I can copy the same program for both inputs but say accidentally both buttons are pressed at the same time. Will the logo try to run both programs and 'mess' up the cycling.

ixo65

Try this.

But I don't what function the block B015 has ...

B015 Is an On-Delay where for any reason if the system needs to be turned of the switch can be pressed down for 2 seconds and the system will pause. If I want to continue it again pressing the switch will start the cycling from where it left off. 

ixo65

Have you take a look a my last upload of your program (V3)?

Is this what you want.

Yes thank you for your help. I will find a way to incorporate the B015 block in your solution as I want to be able to stop it whenever during the cycling. 

Thank you again. 

ixo65

Version 4.

 Works fine now. Thank you so much for your help. I appreciate it.

ixo65

 

Prxsh

 

ixo65

Version 4.

 Works fine now. Thank you so much for your help. I appreciate it.

I'm confused ... 

No download of version 4, but you mean it works fine? 

 I opened it then. I'm not sure why it said that. But I have tried it. The program works fine. I still need to get around the analog blocks and learn the function. I will maybe give an update here if I am still confused. Thank you. I cannot access it now as I have finished work and I dont have the software on my personal laptop.