LSC has a block hours counter. This you use for that.

But note: This counter counts only complete minutes.

Examples:

Q1 is 50s active, the counter count not.
Q1 is active 1 min 38s, the counter counts 1 min.
Q1 is active 3 min 10s, the counter counts 3 min.

There is no space in the message text B010 to show you this. Then must you insert a second message text. With the cursor keys up and down can you then select between the both message  texts.

Draven2

The counter works fine, but when i load changes to logo the counters hours/minutes will be overwritten, is there a way around this ?

No, this not possible.

But for the program transfering to the LOGO! note the values of the hours and the minutes.

Then can you enter the values in the "Start tine for OT".

Draven2

Hello.

I am struggeling with this, I have created a new project. And what are the right steps ?

1.Create communication ?

2.Create tag table ? I want to see digital inputs and outputs and my two analouge values.

1.) You don't need to create a communication, that makes the LOGO! alone.

2.) You can, but you must not.
Digital I/O variables can you directly select in the of LWE (I and Q). For the analogue values you can transfer via Parameter VM Mapping to the VM area the Ax values of B001 and B002. Then can you select the corresponding VWs in LWE.