SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Analog module firmware 1.0.5

7/22/2022 10:33 AM	Rate (0)
paro70 Member Joined: 3/7/2022 Last visit: 10/26/2023 Posts: 2 Rating: (0)	Hello, I have an analog module 6ES7 231-4HA30-0XB0 firmware 1.0.5. PLC 1214C 6ES7 214-1AG40-0XB0 firmware 4.5 reports error in lower-level component. I suspect that the firmware of the analogue is too low. The analog module is working properly! Blinking red led ERROR on PLC. TIA Portal v.17 Is there an update to the module? I was looking for and did not find it. Thank you Attachment 2022-07-22 10_28_50-.png (450 Downloads)
	Last edited by: paro70 at: 07/22/2022 10:35:43 Last edited by: Jen_Moderator at: 07/22/2022 12:40:56 Text edited for better reading.
Suggestion To thank Quote Answer

7/22/2022 11:25 AM	Rate (0)
Havillant Comet Silver Member Joined: 8/6/2018 Last visit: 12/19/2025 Posts: 366 Rating: (46)	Hello, Could you send us the diagnostic buffer in txt format? Thanks you

Suggestion To thank Quote Answer

7/22/2022 11:53 AM	Rate (0)
paro70 Member Joined: 3/7/2022 Last visit: 10/26/2023 Posts: 2 Rating: (0)	Attachment Diagnostics.txt (471 Downloads)

Suggestion To thank Quote Answer

7/22/2022 3:32 PM	Rate (0)
0_Einstein Grandmaster-Expert Joined: 7/7/2010 Last visit: 12/31/2025 Posts: 16341 Rating: (2521)	Since this is an s7-1200, with power removed from the PLC and analog input module, reseat the bus connector slider and make sure it is making good connection. Verify the analog input module terminals are installed correctly. Verify the analog input module power, common, and ground terminals are wired correctly with no stray strands (easy if crimped ferrules are used on wiring terminations). paro70 Hello, I have an analog module 6ES7 231-4HA30-0XB0 firmware 1.0.5. PLC 1214C 6ES7 214-1AG40-0XB0 firmware 4.5 reports error in lower-level component. I suspect that the firmware of the analogue is too low. The analog module is working properly! Blinking red led ERROR on PLC. TIA Portal v.17 Is there an update to the module? I was looking for and did not find it. Thank you
	science guy
Suggestion To thank Quote Answer