Dear experts,

I am configuring two Profibus DP (slave) stations with Step_7.

Station 1 is based on Wago coupler 750-333, followed by I/O modules like 750-455, 750-1405, 750-1504.  The configuration of this station was easy, because after having installed the GSD files from Wago, the configuration was just dragging and dropping the coupler and the modules to the Profibus icon.

But station 2 gets me.  This station is based on Wago coupler 750-333 too, but the modules are from Beckhoff --- three of them are KL2424, two are KL2535.  Step_7 (HW config) does NOT allow dragging KL2424 or KL2535 (Beckhoff products) into 750-333 (Wago product) slots.

Please, experts, help me solving this problem.  Thank you for your time!

Hello,

maybe Beckhoff modules are same type as Wago modules (internally compatible) so you can use configured Wago modules as real Beckhoff. Check Beckhoff modules specification and compare with Wago modules what you expect insert to coupler.

To be clear, your Beckhoff modules working on that Wago coupler or what is your situation? Right now is not all clear to me.

In the past it was exactly like that. You could make configuration for Beckhoff while having hardware from Wago or other way around. You could even mix them in hardware. I don't know if it's still true as Beckhoff and Wago quit cooperation.

Anyway - try to make configuration for you Beckhoff's modules with Wago equivalents in HWConfig.

atapia

Hello, were you able to solve it? I have the same problem

The user 詹老师 can't give you an answer because he is no longer a member of this member.