Technology Team

Hello,

MC_Home without additional settings works only on the active encoder.

8.3 MC_Home V7 (S7-1500, S7-1500T)

// new setting with V7:  Sensor

8.11 MC_SetSensor V7 (S7-1500T)

//  see Mode  1-3

https://support.industry.siemens.com/cs/ww/en/view/109812057

 Thanks for the answer. I use version 6. Do I need to switch to tia 18?

Seward

Good afternoon. I am using two encoders for a technology object. When called ms_home with mode 0 and 10, it affects two encoders. Is it possible to use these modes for one encoder? Thanks for the answer.

Could you please explain how the two encoder configuration looks like? I imagine an inner and outer control loop, but then again the motor drive would handle the inner control loop. Mention also which equipment is used. 

Use a ZIP archive file to add several screen captures into one file. It is then easier to attach that file to your next post.

qwazee

 

Seward

Good afternoon. I am using two encoders for a technology object. When called ms_home with mode 0 and 10, it affects two encoders. Is it possible to use these modes for one encoder? Thanks for the answer.

Could you please explain how the two encoder configuration looks like? I imagine an inner and outer control loop, but then again the motor drive would handle the inner control loop. Mention also which equipment is used. 

Use a ZIP archive file to add several screen captures into one file. It is then easier to attach that file to your next post.

 This is a production line. At different points in time, I need to control by different encoders. One encoder should not be zeroed, the other works in the passive homming mode