Hello,

Thanks.

Hi Programacao02,

Do you have this option activated when you enable protection?

Hello, you can use know-how protection, write protection anda copy protection on each block individually.

Thanks you

 Hello, I have "PUT/GET" checked, but when I use some level of protection, this checkbox changes to unchecked and becomes unavailable, so I can't change it again.

Hazard_7

Hi Programacao02,

Do you have this option activated when you enable protection?

 Well, I hadn't thought of that, maybe this could be a solution, I'll test it to see how it works. Thank you for the tip.

Havillant Comet

Hello, you can use know-how protection, write protection anda copy protection on each block individually.

Thanks you

Thanks a lot for the tip, I managed to test this and it worked fine. I had to use only the "hmi access" level and check the "put/get" option.

qwazee

 

Programacao02

 Hello, I have "PUT/GET" checked, but when I use some level of protection, this checkbox changes to unchecked and becomes unavailable, so I can't change it again.

Hazard_7

Hi Programacao02,

Do you have this option activated when you enable protection?

You have set the security level too high. Look at the following picture to set the access level properly. You need only one password as indicated by the 2nd arrow.

Then follow that up with the put/get setting as Hazard_7 suggested.